UTR1 - U-Tube Recovery 1 Cogeneration Series

For Large Engine and Compact Design

UTR1 - U-Tube Recovery 1 Cogeneration Series

The UTR1 is applied primarily where confined area restrictions vs. heat transfer requirements must be considered as a priority to the combined features of the HRSR. Its compact industrial design allows for maximum BTU recovery relative to the space allotted for installation. Finned tube spacings range from bare tube heating surface up through 8 fins per inch, depending on the fouling factor requirements. Standard fin to tube attachment using the nickel braze/weld fin to tube process allows no fin to tube separation to 2,000°F.

The UTR1 can be located above the engine or on the floor for convenient installation. With over 170 standard configurations to choose from, the UTR1 can be designed to meet the closest pinch point requirements when installation space is not an issue. Easy access allows for quick removal of finned tube rows or core assemblies without disturbing the exhaust gas connections and allows for routine inspections and/or cleaning requirements.

Engine Exhaust Application
Capacity: 200kW to 10MW
Entering gas temps: up to 1,600°F
Heat Sink Types: process water, boiler feedwater, ethylene glycol or thermal transfer fluids

Features
  • Parallel piping flow arrangement for high liquid flow.
  • Series piping flow arrangement
  • Fin tube rack assemblies (spaced for accessible cleaning)
    – Tube materials: carbon steel, TP316 stainless
    – Fin materials: carbon steel, TP304, aluminum
    – Methods of finned tube attachment: nickel brazed, Al-Fuse™ and welded
  • Factory insulation (optional): 2" to 6" thickness available
  • Inspection door for accessing fin tubes
  • Inspection door (optional) for heating surface cleaning
  • 10 gauge carbon steel seal welded exterior
  • 3/4" NPT vent
  • ASME stamp (optional)
  • Lifting lugs
  • Exhaust transition (optional)
  • 3/4" NPT drain
  • H-Beam support
  • 1-1/2" NPT condensate cleanout drain (optional)
Optional Equipment
  • Inspection doors for easy access and cleaning
  • Exterior exhaust gas bypass and actuator assemblies
  • Exhaust piping to UTR1 transitions
  • Rotating sootblowers (automatic or manual)